Safran SecureSync 2400 User Manual page 142

2.15 Configure NTP
1. Navigate to
2. The
3. The
126
MANAGEMENT > NETWORK: NTP
NTP Setup screen appears. The
recognized NTP servers. Click the GEAR icon in the upper right-hand
corner of the NTP Servers
NTP Servers window opens. Should the list be empty, no servers have
been added yet. In the event that added servers are not displayed in the
NTP Setup screen/NTP Servers panel, they could not be resolved. Verify
the IP address. Note that System servers cannot be edited or deleted.
To ADD a new server, click the PLUS icon in the upper right-hand
corner, and proceed to the next step.
Note:
erence, "NTP" must be enabled as both the Time and 1PPS
references in the Reference Priority table. See
figuring Input Reference Priorities" on
To EDIT an existing server, click the corresponding ACTION GEAR
button, and proceed to the next step.
To REMOVE a server (and its associated configurations), click the X-
button next to it, then confirm by clicking OK.
NTP Servers
panel.
In order for other NTP Servers to be a valid ref-
CHAPTER
Setup.
panel displays a list of
"Con-
page 205.
•
2 SecureSync 2400 User Manual Rev. 5.2