Safran SecureSync 2400 User Manual page 568

APPENDIX
Event Broadcast Input: Status Window
To view the current settings of the Event Broadcast Input, (also referred to as
'Reference'), go to its Status window. For instructions, see:
put Configuration Settings" on
The Web UI list entry for this card is: Event Broadcast.
The Status window displays the following settings:
Event Broadcast Time Code Formats
The following ASCII-based time code formats are available:
Event Broadcast Format 0
E x a m p l e
SSSSSSSSSS.XXXXXXXXX<CR><LF>
Where:
552
Event Capture: The processing of events on the Event Input port J2. When
set to "Disabled", no event messages will be queued. When set to
"Enabled", event messages will be triggered (if a valid Format is selected).
Event Active Edge: The signal edge used for triggering events on Event
Input port J2.
Latest Event Message: The last message sent. This can be cleared with the
Clear button.
m e s s a g e :
SSSSSSSSSS
.
page 363.
10-digit Seconds Time (references
st
from January 1 , 1970)
Decimal Point Separator
"Viewing Input/Out-
SecureSync 2400 User Manual