Setting Gnss Receiver Dynamics - Safran SecureSync 2400 User Manual

3.3 Managing References
In Mobile Mode no surveys will be carried out since the position status is updated
in near real-time. SecureSync will go into synchronization shortly after beginning
to track satellites.
The Mobile Mode should only be selected if your SecureSync unit will NOT
remain stationary at all times, i.e. instead of being operated in a building, it is
installed in a mobile platform (such as a vehicle, ship, plane, etc.).
3.3.3.4

Setting GNSS Receiver Dynamics

Receiver Dynamics further refine the reception characteristics for the individual
receiver modes and determine if the receiver will automatically resurvey after a
reboot.
For more information about the GNSS Survey, see
Survey" on
For more information on Receiver Modes, see
on page 231.
To change/review the GNSS Receiver Dynamics:
1. Navigate to
2. Under the
234
Note: With SecureSync's GNSS receiver configured in
the specified accuracies of SecureSync will be degraded to less than
three times that of
receiver is less than 50 ns to GPS/UTC (1 sigma), hence
is less accurate than 150 ns to GPS/UTC time (1 sigma).
Note: This option only applies to
and SAASM GPS do NOT support this.)
Caution: If you select a setting that does NOT resurvey, and sub-
sequently relocate your unit (antenna) by more than 100 m,
M8T receivers will NOT detect the new position, and hence provide
an incorrect time.
page 236.
INTERFACES > REFERENCES: GNSS
Main tab of the GNSS 0 status window, the line item
Dynamics will indicate the current setting.
Standard Mode. Standard Mode
u-blox M8T
"Selecting a GNSS Receiver Mode"
CHAPTER
3
Mobile
accuracy of the
Mobile Mode
receivers (RES-SMT-GG
u-blox
"Performing a GNSS Receiver
0.
Receiver
•
SecureSync 2400 User Manual Rev. 5.2
Mode,