Configurable Connectors; Bnc Dcls Out; Db15 Multi I/O - Safran SecureSync 2400 User Manual

2.18

Configurable Connectors

This Section covers the two software-configurable connectors on the CPU board
(rear panel): the BNC DCLS OUT connector and the HD15 multi I/O connector.
When you configure an input our output via the DCLS OUT connector or the I/O
connector, you will need to adjust both the pin configuration
on
Web UI
on
You can find the settings for signals currently configured through these two con-
nectors under INTERFACES > OPTION CARDS > Main. The CPU board with the
standard-issue connectors is referred to as "Option Card 0" in the Web UI.
2.18.1

BNC DCLS OUT

The DCLS Out connector can be configured with the following options. See
"Assigning Signals" on page 160
Table 2-6:
DCLS OUT
2.18.2

DB15 Multi I/O

Note on the table below: Both RS485 connectors have optional termination on
their inputs. To select this feature, choose the Web UI feature as listed below that
also includes With Termination in the listing.
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
page 160) and (for some types) the settings for that input or output via the
("Configuring Input References" on page 161
page 169).
DCLS Output Options
Location
BNC Connector
(rear Panel)
for detailed instructions.
Available Signal Types
1PPS Output (default)
IRIG Output
HaveQuick Output
GPIO Output
2.18 Configurable Connectors
("Assigning Signals"
and "Configuring Outputs"
Web UI Selection
PPS_OUT | DCLS_TTL
IRIG_OUT | DCLS_TTL
HQ_OUT | DCLS_TTL
GPIO_OUT | DCLS_TTL
157