2]: Saving Refererence Priority Configuration - Safran SecureSync 2400 User Manual

APPENDIX
Table 5-4:
50-pin ribbon cable
Washer, flat, alum., #4, .125 thick
Screw, M3-5, 18-8SS, 4 mm, thread lock
Standoff, M3 x 18 mm, hex, M-F, Zinc-pl. brass 2
Standoff, M3 x 12 mm, hex, M-F, Zinc-pl. brass 1
Cable tie
In addition to the parts supplied with your option card ancillary kit, you will need
a #1 Phillips head screwdriver, and may need a cable tie clipper and 6mm nut
driver.
5.2.2.5

[2]: Saving Refererence Priority Configuration

When adding or removing option cards with reference inputs such as IRIG Input,
ASCII Timecode Input, etc., any user-defined Reference Priority configuration will
be reset back to the factory default. This means that you will need to re-configure
the Reference Priority table at the end of the installation procedure.
To avoid this manual re- configuration, you can save your configuration: For
instructions, see
Saving the System Configuration Files
To save (back up) the system configuration files:
1. Navigate to
2. In the
370
Parts list, Ancillary Kit [1204-0000-0700]
Item
Note: This step is optional.
"Saving the System Configuration Files" on
TOOLS > SYSTEM:
Actions panel, click the
Quant. Part Number
1 CA20R-R200-0R21
2 H032-0440-0002
5 HM11R-03R5-0004
HM50R-03R5-0018
HM50R-03R5-0012
2 MP00000
Upgrade/Backup.
Save Configuration
page 343.
button.
SecureSync 2400 User Manual