Using Ac Input Power; Using Dc Input Power - Safran SecureSync 2400 User Manual

Table 2-2:
240x-
240x-
240x-
240x-
Before connecting power to the unit, be sure that you have read all safety inform-
ation detailed in section
2.9.1

Using AC Input Power

Connect the AC power cord supplied in the SecureSync ancillary kit to the AC
input on the rear panel and the AC power source outlet.
2.9.2

Using DC Input Power

CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
SecureSync 2400 Power Supply via Part Number
Part number Connections
0
xx 1
3
xx 1
4
xx 1
6
xx 1-2 (Hot Swap)
Note: Important! SecureSync is earth grounded through the AC
power connector. Ensure SecureSync is connected to an AC outlet
that is connected to earth ground via the grounding prong (do not
use a two prong to three prong adapter to apply AC power to
SecureSync).
Note: DC power is an option chosen at time of purchase. The rear
panel DC input port connector is only installed if the DC input option
is available. Different DC power input options are available (12 V
with a voltage range of 12 to 17 V at 10 A maximum or 24/48 V
input with a voltage range of 21 to 60 V at 5.5 A maximum). Review
the DC power requirement chosen, prior to connecting DC power.
DANGER! GROUNDING: SecureSync is NOT earth grounded through
the 12 V (2-Pin) power connector. Before connecting the unit to a
DC
DC power source, connect to earth ground with a grounding ring via
the grounding post.
AC (fixed)
12 V DC (fixed)
24 V DC (fixed)
AC, DC (12 V or 24 V), in any combination
"SAFETY" on page 45.
2.9 Connecting Supply Power
Power Supply
DC
DC
53