Ntp Peers: Adding, Configuring, Removing - Safran SecureSync 2400 User Manual

2.15 Configure NTP
5. Click Submit, or press Enter.
2.15.8.3

NTP Peers: Adding, Configuring, Removing

To add, configure, or remove an NTP Peer:
1. Navigate to
2. The
3. The
128
Mark as Preferred: Click here to make this server the preferred
server. For more information, see
ation" on page 121.
Note:
than one NTP Server in the NTP Servers table as being
Preferred. Typically, only one NTP server should be selec-
ted as Preferred.
MANAGEMENT > NETWORK: NTP
NTP Setup screen appears. The
recognized NTP peers.
Note: Should the list be empty, no servers have been added
yet. In the event that added peers are not displayed, they could
not be resolved. Verify the IP address
To EDIT the settings of an NTP Peer, click the GEAR button next to it,
and proceed to Step 3 below.
To ADD a new NTP Peer, click the PLUS icon in the top right corner of
the NTP Peers
To REMOVE an NTP Peer (and its associated configurations), click
the X-button next to it.
NTP Peers edit window opens:
"Configuring "NTP Stratum 1" Oper-
It is not normally recommended to select more
NTP Peers
panel.
CHAPTER
Setup.
panel displays a list of
•
2 SecureSync 2400 User Manual Rev. 5.2