Safran SecureSync 2400 User Manual page 84

Hide thumbs Also See for SecureSync 2400:

Table of Contents

2.12 Setting up an IP Address

C. Enter the

The remainder of the configuration settings can be performed via the Web UI

(accessed via an external workstation with a web browser such as Firefox

3. Press down to highlight the current DHCP state [ON or OFF], and press

ENTER to change the setting.

4. Use the arrow keys to select OFF, and press the ENTER key twice

(once to enter the setting, and once to confirm when the con-

firmation menu appears to the right).

1. Select the IPv4 Address row, press ENTER to allow changes, and

use the up and down arrows to change 000.000.000.000/00 to the

value of the static IP address and subnet mask/network bits to be

assigned (for a list of subnet mask values refer to the table

mask values" on

2. Press the

ENTER key once to enter the setting, then again to con-

firm the new setting in the confirmation menu.

Gateway Address

1. Highlight the gateway row. Press the

2. The display will change, allowing you to input an address at

000.000.000.000. Enter the gateway address here. The address

entered must correspond to the same network IP address assigned to

). For more information, see

(if required)

"The Web UI HOME Screen" on

key once to enter the setting.

SecureSync 2400 User Manual Rev. 5.2

Troubleshooting