Safran SecureSync 2400 User Manual page 256

3.3 Managing References
The objective of the GNSS Survey is to re-discover the current antenna position.
Relocating SecureSync
The Delete Position command may need to be used if a SecureSync system is
physically moved, and it did not self-initiate a new survey automatically. Note
that neglecting to delete the old position data and discover the new position data
will cause SecureSync not to go into synchronization state.
Sanitization
The Delete Position command must also be used when sanitizing a SecureSync
unit (ensuring that no trace of position data remains on the unit).
Deleting the GNSS position
To delete the GNSS position:
1. Disconnect the GNSS antenna from the SecureSync unit (this is required
2. Navigate to
3. Click on the GEAR button next to the GNSS Reference (typically, there is
4. SecureSync will initiate a GNSS self survey.
240
a GNSS antenna is connected to SecureSync
the GNSS receiver can track at least four satellites continuously
and the GNSS receiver it is configured to operate in
Note: A self survey
only when sanitizing
Interfaces > References: GNSS
only one reference, numbered "0"). The
Locate the Delete Position box, check it, and click Submit.
will take at least 2000 seconds (33 minutes).
the unit).
GNSS 0
CHAPTER
Standard Mode.
Reference.
window will open:
•
3 SecureSync 2400 User Manual Rev. 5.2