Safran SecureSync 2400 User Manual page 410

APPENDIX
The fields displayed are:
1PPS Input: Edit Window
To configure the settings of the PPS Input (also referred to as 'Reference'), go to
its Edit window. For instructions, see:
on page 364.
The Web UI list entries for these cards are:
The connector number for the input is: J1
The Edit window allows the configuration of the following settings:
394
Signature Control: Displays the current configuration of Signature Control.
See "Signature Control" on
Frequency: Indicates the configured frequency of the 1PPS output signal.
Offset: Displays the configured Offset (to account for cable delays or other
latencies).
Edge: Shows if the on-time point of the 1PPS output is the rising or falling
edge of the pulse.
Pulse Width: Displays the configured Pulse Width of the 1PPS output. The
Pulse Width is displayed in nanoseconds (ns). The default Pulse Width is
200 milliseconds.
1PPS In/Out
1PPS In/Out, Fiber
page 183.
"Configuring Option Card Inputs/Outputs"
SecureSync 2400 User Manual