Configuring The 10 Mhz Output - Safran SecureSync 2400 User Manual

3. The
4.
2.20.3

Configuring the 10 MHz Output

A 10 MHz Output is available on the rear panel of the SecureSync 2400 Time and
Frequency Synchronization System.
To configure the 10 MHz output:
1. Navigate to
2. In the panel on the right, click the GEAR button next to the
3. The
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
1PPS Output Edit window will display, allowing the following items to be
configured:
Signature Control: Determines when the output is enabled. For more
information, see "Signature Control" on
Offset [ns]: Allows to offset the system's 1PPS on-time point, e.g. to com-
pensate for cable delays and other latencies [range = –500000000 to
500000000 ns = ±0.5 s].
Edge: Used to determine if the on-time point of the 1PPS output is the
rising or the falling edge of the signal.
Rising
Falling
Pulse Width [ns]: Configures the Pulse Width of the 1PPS output.
[range = 20 to 900000000 ns = 0.0 μs to 0.9 s]
[default = 200 ms]
Click Submit.
INTERFACES >
(white on orange).
that you want to edit.
10 MHz edit window will display. Choose a value from the
trol field drop-down list to determine what SecureSync shall do with the out-
put signal in the event its input reference is lost. For more information, see
"Signature Control" on
page 183.
OUTPUTS, or to
page 183.
2.20 Configuring Outputs
INTERFACES > OPTION CARDS
10 MHz
Signature Con-
output
171