Configuring Notifications - Safran SecureSync 2400 User Manual

4.2 Notifications
Also, this page allows the desired email recipient's address for that particular
event to be specified. Each event can be configured with the desired email
address that is specific to just that one event only. Note that only one email
address can be specified in each Email Address field. If desired, the same email
address can be used in all of the fields, or different addresses can be used for dif-
ferent events.
All available SecureSync events that can generate a notification to be sent are loc-
ated under different tabs in the Notification Events panel: Timing, GPS, and Sys-
tem.
The SecureSync Events that can automatically trigger a notification are listed in
the Event column. It is possible to:
4.2.1

Configuring Notifications

To configure Notifications:
1. Navigate to
264
Note: Whether or not notifications are enabled/disabled for a given
event, the occurrence of the event is always logged.
Mask the alarm generation for specific events (prevent the alarm)
Enable "SNMP" (to send out an SNMP trap)
Send an email to the address specified in the corresponding "Email
Address" column.
MANAGEMENT > OTHER:
screen will display:
Notifications. The
CHAPTER •
4 SecureSync 2400 User Manual Rev. 5.2
Notifications