Ntp Output Timescale - Safran SecureSync 2400 User Manual

2.15.6

NTP Output Timescale

You can choose the timescale SecureSync will use for the time stamps it sends
out to its NTP clients and network nodes. This is done by setting SecureSync
System Time timescale. The options are UTC, TAI and GPS. Typically, UTC is used
for network synchronization.
Note that the System Time affects not only NTP output, but also all other aspects
of time management e.g., time distributed via channels other than NTP, logging,
and time displayed in the Web UI.
If SecureSync is operated as a Stratum 2 server, i.e. as a client to a Stratum 1
server (see
server will override SecureSync's System Timescale, should it be different.
To change the system timescale SecureSync will use for its NTP output (and
other outputs):
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
1. Navigate to MANAGEMENT > NETWORK: NTP
2. In the NTP Actions
3. In the dialog window that displays, click OK.
"Configuring "NTP Stratum Synchronization"" on
Note: IMPORTANT: Make sure you select your desired timescale!
Using the wrong timescale will inevitably result in an undesired time
error in your NTP clients.
panel, click Restore Default NTP
2.15 Configure NTP
Setup.
Configuration.
page 122), the other
119