The Ntp Servers And Ntp Peers Panels - Safran SecureSync 2400 User Manual

2.15 Configure NTP
the network that it is now at Stratum 15. A status of Stratum 15 will cause the net-
work to ignore SecureSync as an NTP time reference.
For more information about Holdover, see
2.15.8.1

The NTP Servers and NTP Peers Panels

The NTP Servers and NTP Peers panels display which servers in the network are
set up at higher or equal Stratums (Servers or Peers, respectively), and their con-
figurations. These panels are also used to add, configure, or remove NTP Servers
and Peers.
The NTP Servers and NTP Peers panels are part of the NTP Setup screen (see
"The NTP Setup Screen" on
> NETWORK: NTP Setup.
Information provided in the NTP Servers and NTP Peers panels
The following columns are used to break down the status information for recog-
nized NTP Servers and NTP Peers.
124
Note: For information on how to
Clients" on page 118.
page 114), which can be accessed via MANAGEMENT
Note: Servers will be displayed in the
resolved. They will, however, always be displayed in the
order to reconfigure them, if necessary.
"Holdover Mode" on
view NTP Clients, see
Status view only if they can be
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
page 246.
"Viewing NTP
Setup view in