Using Zeroconf; Setting Up An Ip Address - Safran SecureSync 2400 User Manual

2.12 Setting up an IP Address
2.11.1

Using Zeroconf

Connect to the Web UI of your SecureSync unit in these steps:
1.
2. Connect the SecureSync to a router on your LAN via ETH0 or ETH1 con-
3. Connect the power supply to the SecureSync unit.
4.
Once you logged into the SecureSync via zeroconf, you can retrieve the DHCP
address for future use:
See "Setting up an IP Address" below
more information.
2.12

Setting up an IP Address

In order for SecureSync to be accessible via your network, you need to assign an
IP address to SecureSync, as well as a subnet mask and gateway, unless you are
64
Obtain the last 6 digits of the MAC address: e.g., "0E 51 7B". The MAC
address can be found:
On the front panel display under the Network
On the serial number label on the side on the unit
Through the CLI using the ifconfig command.
nector.
On a connected computer, open your web browser and in the URL field
type the following:
securesync-[xxxxxx].local/
where the [xxxxxx] of the hostname are the last six digits of the MAC
address.
(If your browser doesn't recognize the information as an address, it may be
necessary to add the prefix http:// or https://)
You should now connected to the unit Web UI and can login using the fact-
ory default credentials:
Navigate to MANAGEMENT: NETWORK > Network Setup. In the Ports
panel, click on the information button next to each Ethernet port. The
popup window will display the assigned DCHP IP address for the selected
port.
Username: spadmin
Password: admin123
or "Accessing the Web UI" on page 71
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
menu
for