Table of Contents
Advertisement
Other NTP Services that can be configured via the NTP Services panel by click-
ing the GEAR icon are:
The NTP Status Summary panel
... provides a real-time overview of your key NTP network parameters. For more
information, see
2.15.3
Dis-/Enabling NTP
If you applied NTP configuration changes e.g., added a new NTP Server,
SecureSync usually will stop and re-start the NTP Service automatically once you
clicked Submit. Changes made to NTP configurations will also take effect after
SecureSync is either rebooted or power-cycled.
You can, however, also disable or enable the SecureSync NTP Service manually.
To disable and enable your NTP Service:
Changes made will now take effect and NTP operation will be restored shortly
after this operation is performed.
CHAPTER
•
2
SecureSync 2400 User Manual Rev. 5.2
NTP
ON/OFF: This switch enables and disables NTP. See
NTP"
below.
Note:
When applying any changes NTP will usually restart auto-
matically. Use this switch only to force a restart.
Expert
Mode: Turning this switch ON enables direct access to the
conf
file, thus bypassing the SecureSync Web UI. [Default =OFF] See
Expert Mode" on
Note:
Safran Tech Support does not support the editing of the
NTP configuration files in Expert Mode. For additional inform-
ation on editing the NTP.conf file, please refer to
http://www.ntp.org.
Stratum 1 (see
"NTP Reference Configuration" on
"NTP Status Monitoring" on
1. Navigate to
MANAGEMENT > NETWORK: NTP
2. In the
NTP Services
3. A notification window will confirm the status change.
4. In the
NTP Services
page 146.
panel, set the ON/OFF toggle switch to OFF.
panel, set the ON/OFF toggle switch to ON again.
2.15 Configure NTP
"Dis-/Enabling
page 120)
page 317.
Setup.
NTP.-
"NTP
117
Advertisement
Table of Contents
Troubleshooting
