Powering Up/Shutting Down; Powering Up The Unit; Shutting Down The Unit - Safran SecureSync 2400 User Manual

4.1 Powering Up/Shutting Down
4.1

Powering Up/Shutting Down

4.1.1

Powering Up the Unit

1. After installing your SecureSync unit, and connecting all references and net-
2. Observe that the front panel illuminates The time display will reset and then
1. Check the front panel status LED indicators:
For additional information, see
via Front Panel" on
4.1.2

Shutting Down the Unit

To shut down the unit gracefully, it is recommended to employ the Halt com-
mand.
260
work(s), verify that power is connected, and wait for the device to boot up.
Note: SecureSync does not have a power switch. When the
unit is plugged in, the power will be on (unless you have an addi-
tional condition, such as your unit has been halted).
start incrementing the time.
Figure 4-1: SecureSync front panel
The Power
The GNSS LED will be either OFF or flashing HEARTBEAT, since
synchronization has not yet been achieved.
The Alarms
HEARTBEAT (acquiring fix behavior). A FAST blinking pattern would
indicate the unit requires attention.
page 302.
LED should be lit (not flashing).
LED light should be OFF (startup behavior) or
"Status LEDs" on page 4
CHAPTER
and "Status Monitoring
•
4 SecureSync 2400 User Manual Rev. 5.2