The Outputs Screen; The 1Pps And 10 Mhz Outputs - Safran SecureSync 2400 User Manual

2.20 Configuring Outputs
For IRIG frequency and output specifications, see
cifications" on
2.20.8

The Outputs Screen

SecureSync outputs deliver a time or frequency signal to a device that consumes
this signal.
To access the Outputs screen in the Web UI:
1. Navigate to
2. The
2.20.9 The 1PPS and 10 MHz Outputs
The SecureSync includes one 1PPS output and one 10 MHz output. To configure
these outputs, navigate to:
and select the 1PPS Output or 10 MHz Output you would like to see, or con-
figure.
SecureSync's 1PPS output is generated from the oscillator's 10 MHz output and is
aligned to the on-time point. The on-time point of the 1PPS output can be
180
will cause the Mark amplitude to be about 5V
value of 200 results in an output amplitude of about 9V
ance.
Note: These are nominal values only. Actual values will vary from unit
to unit. To adjust the level precisely, connect an oscilloscope to the
output connector when adjusting.
Offset: Provides the ability to account for IRIG cable delays or other laten-
cies in the IRIG input. The Offset value is entered and displayed in nano-
seconds (ns). The available Offset range is -500 to +500 ms.
page 587.
INTERFACES
Outputs screen will display.
While System Status and logged Events are displayed on the left, the Out-
puts panel on the right lists all the outputs detected.
If you have only one output of any type, SecureSync will number that
output 0. Additional outputs will be numbered 1 or above.
If you click the INFO button next to an output, a Status window will
open.
If you click the GEAR button next to an output, the Configuration win-
dow will open.
INTERFACES > OUTPUTS
p-p
and click on OUTPUTS
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
into high impedance. A
into high imped-
p-p
"IRIG Standards and Spe-
(white on orange).