Setting Up A Static Ip Address Via A Dhcp Network; Setting Up An Ip Address Via The Serial Port - Safran SecureSync 2400 User Manual

2.12.2.2

Setting Up a Static IP Address via a DHCP Network

To setup a permanent static IP address, after connecting SecureSync to a DHCP
network:
2.12.2.3

Setting Up an IP Address via the Serial Port

SecureSync's rear panel serial port connector is a standard DB9 female con-
nector. Communication with the serial port can be performed using a PC with a
terminal emulator program (such as PuTTY or TeraTerm) using a pinned straight-
thru standard DB9M to DB9F serial cable.
SecureSync's front panel serial port connector is a standard micro-B USB female
connector.
The serial ports can be used to make configuration changes (such as the network
settings), retrieve operational data (e.g., GNSS receiver information) and log files,
or to perform operations such as resetting the admin password.
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
1. Enter the IP address shown on the front panel information display of your
SecureSync unit into the address field of your browser (on a computer con-
nected to the SecureSync network). If the network supports DNS, the host-
name may also be entered instead (the default hostname is productname-
macaddress. See
MAC address). The start screen of the SecureSync Web UI will be dis-
played.
2. Log into the Web UI as an administrator. The factory-default user name and
password are:
Username: spadmin
Password: admin123
3. Disable DHCP by navigating to
Ports panel on the right, click the GEAR icon next to the Ethernet Port you
are using. In the Edit Ethernet Port Settings
DHCPv4 field. Do NOT click Submit or Apply yet.
4. In the fields below the
IP address, Netmask, and Gateway address (if required). Click Submit.
For subnet mask values, see
5. Verify on the front panel information display that the settings have been
accepted by SecureSync.
6. Enter the static IP address into the address field of the browser, and again
log into the Web UI in order to continue with the configuration; see:
Web UI HOME Screen" on
"Zero Configuration Setup " on
MANAGEMENT > Network
Enable DHCPv4
"Subnet Mask Values" on
page 34.
2.12 Setting up an IP Address
page 63to identify your
Setup. In the
window, uncheck the
checkbox, enter the desired Static
page 71.
Enable
"The
69