Rack Installation - Safran WR-ZEN Series User Manual

2.6

Rack Installation

The device has been designed to be mounted in a standard 19-inch (48.3 cm)
equipment rack and thus respect the following physical dimensions:
To properly mount the device to a rack cabinet:
CHAPTER •
2 WR-ZEN Series User Manual Rev. v5.1
Width: 431 mm
Height: 44mm (1x Rack Unit)
Depth: 300 mm
Caution:
The following guidelines are provided to prevent bodily-injury when
mounting or servicing this unit in a rack:
-This unit should be mounted at the bottom of the rack if it is the
only unit in the rack.
-When mounting this unit in a partially filled rack, load the rack from
the bottom to the top with the heaviest component at the bottom of
the rack.
-If the equipment rack is on wheels, ensure that the brakes are
engaged and that the rack is stabilized.
Note:
Accessories: The screws needed to properly mount the device to the
rack are not shipped with the equipment, nor the system ground kit.
The device already mounts the L-brackets and is provided with a
power cord C13 (European).
Note:
Airflow consideration: There are no standards for airflow in rack sys-
tem but the device should be configured accordingly to the emplace-
ment of hot and cold aisles. The default airflow of the device is from
front-panel (cold) to back-panel (hot).
1. Place the device on the floor or on a sturdy table near the rack.
2. Use a tape measure to verify the interior dimensions of the rack.
3. Carefully lift the device and position the rear of the device between the
equipment rack mounting posts and slide the device into the rack until the
2.6 Rack Installation
23