Safran SecureSync 2400 User Manual page 526

Hide thumbs Also See for SecureSync 2400:

Table of Contents

Ethernet Status

Time and 1pps references are in holdover state, not within spe-

cifications, and PTP clock shall not be a slave to another clock in the

domain. Then, applied to Master Clocks who have just powered on and

have not yet achieved a suitable TFOM value.

Time and 1pps references are in holdover state, not within spe-

cifications, and PTP clock may be a slave to another clock in the

Class assigned to "Slave-Only" clocks.

"Unknown" class.

Address: The IP address currently being used by the PTP inter-

If the PTP Module is set up for DHCP but fails to obtain an IP

address, it will use the Static IP instead. To reacquire a DHCP address,

reset the module via the Main tab in the PTP settings window.

Current Network

Mask: The Network Mask currently being used by the PTP

Gateway: The Gateway address currently being used by the PTP

State: Reports the current state of the PTP State Machine:

Disabled: PTP Ethernet port is Disabled. See PTP Setup/Network

page, PTP Network Settings options.

Initializing: Ethernet link is unplugged/PTP Module is in power-up

state. A Master Clock doesn't leave this state while it can't get the cur-

rent time and synchronization references from SecureSync to syn-

chronize with it.

Listening: PTP module is looking for a Master Clock.

Clock Class Definition

SecureSync 2400 User Manual

Troubleshooting