Setting Up A Static Ip Address Via Ethernet Cable - Safran SecureSync 2400 User Manual

2.12 Setting up an IP Address
The serial ports are account and password protected. You can login using the
same user names and passwords as would be used to log into the SecureSync
Web UI. Users with "administrative rights" can perform all available commands.
Users with "user" permissions only can perform "get" commands that retrieve
data, but cannot perform any "set" commands or change/reset any passwords.
To configure an IP address via the serial port:
1. Connect a serial cable to a PC running PuTTY, Tera Term, or HyperTerminal,
2. Login to SecureSync with a user account that has "admin" group rights,
3. Disable DHCP, type: dhcp4set X off <Enter>, where X is the Ethernet port
4. Configure the IP address and subnet mask, type:
5. Configure the gateway by typing gw4set x y.y.y.y <Enter>
6. Remove the serial cable, connect SecureSync to the network, and access
The remainder of the configuration settings will be performed via the Web UI
(accessed via an external workstation with a web browser such as Firefox
Chrome
2.12.2.4

Setting up a Static IP Address via Ethernet Cable

This procedure will allow you to configure SecureSync using the Web UI directly
via the Ethernet port, if you cannot or do not wish to use a DHCP network.
70
and to your SecureSync. For detailed information on the serial port con-
nection, see "Setting up a Terminal Emulator" on page 554
such as the default spadmin account (the default password is admin123).
you wish to configure (Eth0, Eth1).
Note: For a list of CLI commands, type helpcli, or see
"CLI Commands" on
ip4set x y.y.y.y z.z.z.z <Enter>
(where x is the desired interface (eth0, eth1), "y.y.y.y" is the desired
IP address for SecureSync, and "z.z.z.z" is the full subnet mask for
the network (For a list of subnet mask values, see
ues" on the facing
(where x indicates the interface routing table to add the default gateway
(eth0, eth1), and "y.y.y.y" is the default gateway address).
the Web UI, using the newly configured IP address. (For assistance, see
"Accessing the Web UI" on the facing
®
).
page 555.
page.)
page).
CHAPTER
2
"Subnet Mask Val-
•
SecureSync 2400 User Manual Rev. 5.2
®
or