Advertisement
Error code
Classification
CC72
Finisher related
service call
CC80
CC91
CC92
CC93
CC94
CCF1
CDE0
CDF0
Offset tray related
service call
CE00
Optional
communication
related service call
CE50
Process related
service call
CE90
CF10
Finisher related
service call
F070
Communication
related service call
F090
Circuit related
service call
© 2012 OKI DATA CORPORATION All rights reserved
Contents
Punch RAM read/write error: Abnormality of checksum
value on Hole punch controller PC board is detected
when the power is turned on. [MJ-1101/MJ-1106 (when
MJ-6103 is installed)]
Rear alignment motor abnormality: The rear alignment
motor is not rotating or the rear alignment plate is not
moving normally. [MJ-1101/MJ-1106]
Rear alignment plate home position detection error: The
detection of the home position ends abnormally because
the rear alignment plate has not worked properly.
[MJ-1032/MJ-1033]
The detection of the home position of the gripper arm
ends abnormality.
The movable tray exceeds its upper limit.
Knurled roller shift solenoid abnormality: An abnormality
occurs in the knurled roller shift solenoid. [MJ-1032]
1st fan motor abnormality: The 1st fan motor is locked
abnormally. [MJ-1032]
Tray safety switch abnormality -
The tray safety switch turned on during tray operation
(moving up or down).
Paddle motor abnormality: The paddle motor does not
rotate properly.
Initialization error of the offset tray: The home position of
the separator cannot be detected when the power is
turned ON.
Communication error between finisher unit and puncher
unit: Communication error between the finisher controller
PC board and punch controller PC board.
Temperature/humidity sensor abnormality: The output
value of this sensor is out of a specified range.
Drum thermistor abnormality: The output value of the
drum thermistor-K is out of a specified range.
Communication module SRAM reading failure. [MJ-1101]
Communication error between System-CPU and Engine-
CPU
SRAM abnormality on the SYS board
8 - 17
Troubleshooting
P. 8-171
P. 8-171
P. 8-173
P. 8-173
P. 8-174
P. 8-174
-
P. 8-174
P. 8-174
P. 8-135
P. 8-128
P. 8-128
P. 8-175
P. 8-138
P. 8-136
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
8
Advertisement
