Advertisement
(5)
Take off the converter PC board from the logic PC board (LGC board).
(6)
Connect the 10-pin side of the harness jig for board connection to the connector (CN2) of the
converter PC board.
(7)
Connect the 15-pin side of the harness jig for board connection to the connector (CN15) of the
finisher control PC board.
Notes:
•
Be sure to release the connection cable from the connector (CN15) of the finisher control PC
board when the hole punch unit (MJ-6103) has been installed.
•
Be careful not to short-circuit any part of the converter PC board.
© 2012 OKI DATA CORPORATION All rights reserved
Fig.11-58
CN2
Fig.11-59
CN15
Fig.11-60
11 - 61
ES9160 MFP / ES9170 MFP
FIRMWARE UPDATING
11
Advertisement
