Advertisement
9.2.11
License re-registration using the one-time dongle
[ 1 ] Re-registration when the board is replaced
The license registered using the one-time dongle can be re-registered only in the same equipment.
When the SYS board or SRAM board is replaced, follow the procedures for re-registration given below.
(1)
Start up with the Setting Mode (08).
(2)
Key in [3840], and then press the [START] button.
(3)
Press the [INSTALL] button.
(4)
Install the one-time dongle in the equipment (the one which you used for registering the selected
license), and then press the [OK] button.
(5)
Select the license to be installed, and then press the [INSTALL] button.
(6)
The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(7)
After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [CLOSE] button. Then check that the one-time
dongle, which you used for uploading the selected license, is installed in the equipment.
(8)
Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be returned, repeat from step (3). If there are no other licenses
to be returned, press the [CLOSE] button, and then turn the power OFF.
Notes:
This procedure is available only with the one-time dongle used for the previous registration, since
the model information registered in it is utilized. Use the same one-time dongle and the
equipment when registering the license.
[ 2 ] Re-registration when the equipment is replaced due to malfunction
When the equipment has to be replaced due to a malfunction, return the license registered in the
equipment to the one-time dongle and register it to the new equipment following the procedure below.
Notes:
The one-time dongle to be used is the one for the previous registration of the license. The license
is deleted from the equipment and is stored in the one-time dongle.
Do not perform the deletion of Converter for PDF-Archive since it is deleted without any return to
the one-time dongle.
(1)
Start up with the Setting Mode (08).
(2)
Key in [3840], and then press the [START] button.
(3)
Select the license to be returned, and then press the [REMOVE] button.
(4)
Install the one-time dongle in the equipment (the one which you used for uploading the selected
license), and then press the [OK] button.
(5)
The Remove screen is displayed. Then press the [YES] button.
If this screen is not displayed, check that the one-time dongle is installed in the equipment
properly.
ES9160 MFP / ES9170 MFP
REPLACEMANT OF HDD/PC BOARDS
© 2012 OKI DATA CORPORATION All rights reserved
9 - 28
Advertisement
