Advertisement
[CC30] Stack transport motor abnormality
* You receive a [CC30] error when the [EA70] error occurs three times in succession.
Classification
Finisher related service call
MJ-1101
Check Item
Stack transport belt
Stack transport motor (M5)
Replacement part
Stack transport motor (M5)
Finisher controller PC board
MJ-1106
Check item
Stack transport belt
Stack transport motor
Parts to be replaced
Stack transport motor
Finisher control PC board
[CC31] Transport motor abnormality
* You receive a [CC31] error when the [ED12] error occurs three times in succession.
Classification
Finisher related service call
MJ-1101
Check Item
Stack transport roller
Transport motor (M2)
Replacement part
Transport motor (M2)
Finisher controller PC board
MJ-1106
© 2012 OKI DATA CORPORATION All rights reserved
Stack transport motor abnormality: The stack transport motor is
not rotating or the stack transport belt is not moving normally.
If there is mechanical problem when the stack transport belt is
moved, fix the mechanism.
Check the connectors and harnesses between the stack
transport motor (M5) and the finisher control PC board (CN10).
Measures
Move the stack transport belt.
Fix any mechanical problem.
Check if the connector (CN17) on the finisher controller PC board is
disconnected from the stack transport motor (M8) and the
harnesses are open circuited. Correct if so.
Remark
Transport motor abnormality: The transport motor is not rotating
or the stack transport roller -1 and -2 is not rotating normally.
If there is mechanical problem when the stack transport roller -1
and -2 are rotated, fix the mechanism.
Check the connectors and harnesses between the transport
motor (M2) and the finisher control PC board (CN5).
8 - 163
Contents
Measure
Measure
Contents
Measure
Measure
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
8
Advertisement
