Advertisement
(22) Remove 1 screw and disconnect 1
connector. Take off the duct.
(23) Remove 1 screw and then take off the Damp
Heater cover.
(24) Remove 5 screws. Lift up the rear cover and
then release 3 hooks on the upper side.
Then open the upper side of the rear cover
slightly toward you, and then take off the rear
cover by lifting it up.
ES9160 MFP / ES9170 MFP
DISASSEMBLY AND REPLACEMENT
Duct
Damp Heater cover
Rear cover
© 2012 OKI DATA CORPORATION All rights reserved
4 - 132
Fig. 4-375
Screw
Fig. 4-376
Fig. 4-377
Advertisement
