Advertisement
[B] Update Procedure
(1)
Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2)
Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3)
Remove 1 screw and take off the finisher board access cover.
<When MJ-1101 is connected>
<When MJ-1106 is connected>
(4)
Release the latches and take off the rear lower cover of the hole punch unit.
ES9160 MFP / ES9170 MFP
FIRMWARE UPDATING
Board access cover
Fig.11-47
[1]
Fig.11-48
Rear lower cover
Fig.11-49
11 - 52
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
