Oki ES9160 Maintenance Manual page 426

6.19.2 Registration of the number of punch holes
This registration is to have the Finisher identify which type (number of punch holes) of the Hole Punch
Unit is installed, by storing them in the IC on the hole punch control PC board (HP). Therefore this
registration is required whenever you have replaced the hole punch control PC board (HP).
This registration is performed with a DIP switch [2] and a pushbutton switch [3] on the hole punch
control PC board (HP) [1].
[1]
CPU
LED
[2]
[3]
ON
1 2 3 4
Fig.6-135
ES9160 MFP / ES9170 MFP © 2012 OKI DATA CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 118