Advertisement
[E] Primary scanning data laser writing start position at duplexing
Notes:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[E-1]
Adjustment for long-sized paper
<Procedure>
(1)
While pressing [0] and [5] simultaneously, turn the power ON.
(2)
Press [3]
[FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower
drawer (Refer to *).
(3)
Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4)
Check if the distance E is within 52±0.5 mm.
(5)
If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
[OK] or [INTERRUPT] (Stored in memory)
"100% A" is displayed.
Press [3]
[FAX]
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.05 mm/
step).
[E-2]
Adjustment for short-sized paper
<Procedure>
(1)
While pressing [0] and [5] simultaneously, turn the power ON.
(2)
Press [3]
[FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from the upper
drawer.)
(3)
Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4)
Check if the distance E is within 52±0.5 mm.
(5)
If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
[OK] or [INTERRUPT] (Stored in memory).
"100% A" is displayed
Press [3]
[FAX]
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.05 mm/
step).
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
(Key in code [4019])
[START]
(A grid pattern is printed out.)
(Key in the code [4019])
(A grid pattern is printed out.)
6 - 12
(Adjustment Mode)
[0]
[START]
(Adjustment Mode)
[START]
[1]
[START]
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
