Oki ES9160 Maintenance Manual page 132

4.3.6 Scan motor (M1)
(1) Take off the rear cover.
P. 4-3 "4.1.6 Rear cover"
(2) Take off the upper rear cover.
P. 4-4 "4.1.7 Upper rear cover"
(3) Disconnect 1 connector.
(4) Remove 2 screws and take off the scan
motor with the whole bracket.
Notes:
When installing the scan motor, use the belt
tension jig (spring). The procedure is as
follows.
1. Temporarily fix the screw A and B.
P. 4-18 "Fig. 4-48 "
2. Hook the belt tension jig to the motor
bracket and the flame.
3. The scan motor is pulled by the belt
tension jig. Fix the screw A and then B at
the stopped position.
4. Remove the belt tension jig.
ES9160 MFP / ES9170 MFP
DISASSEMBLY AND REPLACEMENT
© 2012 OKI DATA CORPORATION All rights reserved
4 - 18
Fig. 4-47
Scan motor
A
B
Fig. 4-48
Belt tension jig
Fig. 4-49