Advertisement
Notes:
•
"Update Failed." is displayed at the bottom of the LCD screen when the updating is not
completed properly. "Failed" appears next to the failed item on the status display. Even
though an update fails, do not turn the power OFF until other updates are finished.If "Update
Failed" appears at the bottom of the screen, turn OFF the power and then check the following
items. After confirming and clearing the problems, restart updating from the beginning.
-
Do the USB media meet the conditions to be used for updating?
-
Is the data file written properly on the USB media?
-
Are the USB media installed properly?
-
Do the USB media and equipment operate properly?
•
When an OS update error or HDD update error occurs, "Update Failed" or "Failed" appears
on the screen and the error number appears next to the message.
For details of each error, refer to the following tables.
Error number
O01
FROM writing failed
O02
FROM verification error
O03
File operation error
O04
SRAM flag set error
O05
Electronic key data backup error
O06
Device error
Error number
H01
File creation error
H02
File decompression error
H03
Partition mount error
H00
Other errors
(9)
Press the [ON/OFF] button to shut down the equipment, and then remove the USB media.
[B] Confirmation of the updated data
After the updating is completed, check each data version in the Setting Mode (08) to confirm that the
data were overwritten properly.
P. 11-72 "11.6 Confirmation of the updated data"
© 2012 OKI DATA CORPORATION All rights reserved
OS update Error
Error content
HDD update Error
Error content
11 - 29
ES9160 MFP / ES9170 MFP
FIRMWARE UPDATING
11
Advertisement
