Advertisement
6.13.4
Adjustment of the leading edge position
Notes:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. Also, the RADF position and height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Simplex copying:
(1)
Place the chart provided as an original with its face up on the original tray of the RADF, select [1
Sided -> 1 Sided] and press the [START] button.
(2)
Superimpose the chart on the copy and check the leading edge E of the chart and F of the copy.
Duplex copying:
(1)
Place the chart provided as an original with its face up on the original tray of the RADF, select [2
Sided -> 2 Sided] and press the [START] button.
(2)
Superimpose the chart on the copy and check the leading edge E of the chart and F of the copy.
Fig.6-86 Chart (Original)
© 2012 OKI DATA CORPORATION All rights reserved
E
6 - 75
F
Fig.6-87 Copy
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6
Advertisement
