Advertisement
6.4.8
Adjustment of image density
The image density level can be set at the following codes.
Code
Text/
Text
Photo
photo
7218-0
7219-0
7220-0
to 4
to 4
to 4
<Procedure>
(1)
While pressing [0] and [5] simultaneously, turn the power ON.
(2)
Key in a code and press the [START] button.
(3)
Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4)
Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5)
Press the [OK] or [INTERRUPT] button to store the value in memory. The equipment goes back
to the ready state.
(6)
For resetting the value, repeat step (2) to (5).
(7)
Press the [FAX] button and then select an original mode. Then press the [START] button to
perform test copying.
(8)
If the desired image density has not been attained, repeat step (2) to (7).
© 2012 OKI DATA CORPORATION All rights reserved
Item to be
Present
adjusted
ation
7221-0
Adjustment of
to 4
image density
6 - 27
< Adjustment Mode (05) >
Remarks
When the value is decreased, text becomes
lighter.
Acceptable values: 0 to 10
Notes:
1. Set not to reverse the large and small
number of the setting value
corresponding to the sub code.
Ex.) When the image density level for
7212-0, 7212-1, 7212-2, 7212-3, and
7212-4 is assumed to be "A","B", "C",
"D", and "E" respectively, they should
have the following correlation:
A
B
C
D
E
2.
Remember that the image
specifications and life span of the
replacing parts may not meet the
standard when the setting value is
changed from the default value.
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6
Advertisement
