Advertisement
[C] Assembling carriage wires (Winding the wire around the wire pulley)
<Procedure>
(1)
Pull the Ø3 ball terminal located at the center of the wire into a hole on the wire pulley. One end
of the wire with a hook attached comes to the outside.
(2)
Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be
wound are as follows:
•
3 turns toward the opposite side of the boss
•
3 turns toward the boss side
Notes:
Pay attention to the following when the wires are wound around the pulleys:
-
Do not twist the wire.
-
Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
-
Each turn should be pushed against the previously wound turn so that there is no space
between them.
3 turns
Ball terminal
Hook
© 2012 OKI DATA CORPORATION All rights reserved
3 turns
No space between turns
Color: Silver
[Rear]
Fig.6-35
6 - 53
3 turns
3 turns
Ball terminal
Color: Black
[Front]
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6
Hook
Advertisement
