Advertisement
•
Registration sensor detects jamming of the leading edge of paper:
Registration sensor is not turned ON in a fixed period of time after the leading edge of paper
passed the 1st transport sensor.
Paper jam (E200, E210, E270, E300, E330 and E3C0)
•
During paper feeding from ADU:
Registration sensor is not turned ON in a fixed period of time after the ADU motor is turned ON.
Paper jam (E110)
•
During paper transporting from ADU:
ADU entrance/exit sensors do not detect the paper at the fixed timing
Paper jam (E510 or E520)
•
The 1st/2nd transport sensor and each sensors of PFP/LCF are not turned ON in a fixed period of
time after the feed clutch is turned ON
Paper jam (E220, E310, E320, E340–E360, E3D0 and E3E0: Error code differs depending on the
paper source.) Refer to the error code table in the Service Handbook.
(E) Replace the toner cartridge (
•
Toner density becomes low
Auto-toner sensor detects the absence of the toner
Control circuit
"Install new toner cartridge" displayed: the copying operation disabled
Solution: Open the front cover and replace the toner cartridge with a new one.
Toner is supplied
(F) EPU not installed properly
•
EPU not installed properly
"EPU not installed" is displayed.
Solution: Check if the connector between the EPU drawer and the developer unit is connected.
Then check if the EPU is installed in the equipment properly and close the front cover.
(G) Call for service
Error code is displayed instead of the set number by pressing the [CLEAR] button and [8] button
simultaneously when the "Call for service" is blinking.
Refer to the error code table in the Service Handbook.
ES9160 MFP / ES9170 MFP
OUTLINE OF THE MACHINE
)
copying operation enabled.
3 - 26
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
