Advertisement
[ 1-5 ]
Paper exit tray switching settings
Set the switching timing of the paper exit from the movable tray to the finishing tray.
If the problem is not suppressed through Steps [1-1] to [1-4], perform the following steps.
(1)
Turn OFF the power of the equipment.
(2)
Remove 1 screw and take off the board access cover [1].
(3)
Set the SW1 on the Finisher control board as shown in the figures below.
(4)
Turn ON the power of the equipment while pressing the [0] button and the [8] button
simultaneously.
(5)
Press [Button1] 11 times and then press [Button2] once.
(6)
Press [Button1] 13 times and then press [Button2] once.
(7)
Check the following list and press [Button1] as many times as noted for Adjustment value whose
switching timing you want to select.
Approx. 500 sheets with plain paper
(8)
Press [Button2] once.
(9)
Press [Button1] and [Button2] simultaneously.
(10) Turn OFF the power of the equipment.
(11) Turn OFF all bits of SW1 on the Finisher control board as shown below.
(12) Install the board access cover with 1 screw.
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
[1]
Fig.6-109
Switching timing
0 sheet with plain paper
ON SW1
1
2
3
4
Fig.6-110
SW1
ON
1
2
SW1
Number of blinking times
1
3
ON SW1
1
2
3
4
© 2012 OKI DATA CORPORATION All rights reserved
6 - 100
3
4
Advertisement
