Advertisement
Replacement part
Punch home position sensor (S4)
Punch motor (M3)
Hole punch control PC board (HP)
[CC71] Punch ROM checksum error
MJ-1101/MJ-1106 (When MJ-6103 is installed)
Classification
Finisher related service call
Check Item
Hole punch control PC board (HP)
Replacement part
Hole punch control PC board (HP)
MJ-1033
Error
Flash ROM
[CC72] Punch RAM read/write error
MJ-1101/MJ-1106 (When MJ-6103 is installed)
Classification
Finisher related service call
Check Item
Hole punch control PC board (HP)
Replacement part
Hole punch control PC board (HP)
[CC80] Rear alignment motor abnormality
* You receive a [CC80] error when the [ED14] error occurs three times in succession.
Classification
Finisher related service call
MJ-1101
Check Item
Rear alignment plate
© 2012 OKI DATA CORPORATION All rights reserved
Punch ROM checksum error: Abnormality of checksum value
on Hole punch controller PC board is detected when the power
is turned on.
Board check
Timing of detection
A checksum error occurs on the flash ROM of the Hole Punch
Unit.
The main program of the Hole Punch Unit is damaged.
Punch RAM read/write error: Abnormality of checksum value on
Hole punch controller PC board is detected when the power is
turned on.
Board check
Rear alignment motor abnormality: The rear alignment motor is
not rotating or the rear alignment plate is not moving normally.
If there is mechanical problem when the rear alignment plate is
moved, fix the mechanism.
8 - 171
Measure
Contents
Measure
Measure
Contents
Measure
Measure
Contents
Measure
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
8
Advertisement
