Advertisement
6.15.7
Saddle stitch alignment position adjustment
This adjustment is performed in the Adjustment Mode (05-4826) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
6.15.8
Gripper arm exiting position adjustment
This adjustment is performed in the Adjustment Mode (05-4827) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
6.15.9
Height/skew adjustment
If the height or the skew angle of the Finisher must be adjusted against those of the equipment, follow
the procedure below.
(1)
Open the front cover [1].
(2)
Remove the screw [2] and the wrench [3].
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
0.2mm
-3.0 mm to 3.0 mm
Increasing the value
The alignment plate moves to the center.
Decreasing the value The alignment plate moves to the edge of
paper.
0.2mm
-3.0 mm to 3.0 mm
Increasing the value
The gripper arm exiting position moves farther
to the front side.
Decreasing the value The gripper arm exiting position moves farther
to the rear side.
6 - 86
[2]
[1]
[3]
Fig.6-93
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
