Advertisement
(31) Run the harness through the clamp. Then
run it through the hole in the equipment and
wire it to the front side as shown in the right-
hand figure.
(32) Connect 1 connector and install 3 clamps.
(33) Remove 1 screw and take off the duct.
© 2012 OKI DATA CORPORATION All rights reserved
Fig. 4-384
Fig. 4-385
Duct
Fig. 4-386
4 - 135
ES9160 MFP / ES9170 MFP
DISASSEMBLY AND REPLACEMENT
4
Advertisement
