Advertisement
(5)
Take off the cover plate.
(6)
Connect the download jig with the jig connector (CN602) on the FAX board.
(7)
Turn the power ON using the main power switch while simultaneously holding down the [0] and
[8] buttons.
Updating starts automatically and the LED on the download jig lights.
(8)
After the update is completed properly, the LED on the download jig blinks.
The LED starts blinking approx. 30 sec. after the update starts. It is assumed that the update has
failed if it does not start blinking even though 1 min. has passed. In this case, shut down the
equipment and check the following items. Then clear the problems and restart updating from the
beginning.
•
Is the download jig connected properly?
•
Is the ROM installed to the download jig properly?
•
Is the updating data written on the ROM of the download jig properly?
•
Do the download jig and the equipment operate properly?
(9)
Press the [ON/OFF] button on the control panel and turn the power OFF using the main power
switch and remove the download jig. Install the cover plate.
ES9160 MFP / ES9170 MFP
FIRMWARE UPDATING
Cover plate
Fig.11-71
Fig.11-72
11 - 70
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
