Advertisement
11.5.12 Converter Firmware (MJ-1106)
Important:
•
The harness jig for board connection (HRNS-CNV-DL-JIG) is required for updating the
firmware of the converter PC board of the finisher (MJ-1106) as well as the download jig (K-
PWA-DLM-320).
•
Be sure to connect the equipment and finisher (MJ-1106) before updating the converter
firmware.
•
Be sure to shut down the equipment before installing and removing the download jig.
•
Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Update Procedure
(1)
Install the ROM to the download jig.
Make sure the direction is correct.
(2)
Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3)
Take off the finisher board access cover [1].
© 2012 OKI DATA CORPORATION All rights reserved
[ 1 ]
Fig.11-62
11 - 63
ES9160 MFP / ES9170 MFP
FIRMWARE UPDATING
11
Advertisement
