Advertisement
[EA60] Early arrival jam
Classification
Paper jam in finisher section
MJ-1101
Check item
Finisher
Parts to be replaced
Entrance sensor
Finisher controller PC board
[EA70] Stack exit belt home position error / Stack slider home position error
Classification
Paper jam in finisher section
MJ-1101
Check item
Stack belt exit home position
sensor
Stack transport motor
Parts to be replaced
Stack belt exit home position
sensor
Stack transport motor
Finisher controller PC board
MJ-1106
Check item
Stack belt exit home position
sensor
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
Error content
Early arrival jam
•
Check if there is any paper in the finisher or on the transport
path of the equipment or on the finishing tray. Remove it if there
is.
•
Check if there is any disconnection, incorrect installation or
breakage on the entrance sensor (S1). Correct if any.
•
Check if the connector CN7 on the finisher controller PC board is
disconnected from the entrance sensor (S1) and the harnesses
are disconnected or open circuited. Correct if any.
Error content
Stack exit belt home position error / Stack slider home position error
Measures
Check if the connector CN11 on the finisher controller PC board is
disconnected from the stack belt exit home position sensor (S9) and
the harnesses are open circuited. Correct if any.
Is the harness between the stack transport motor (M5) and the
finisher control PC board (CN10) disconnected or open circuited?
Remark
Measures
Check if there is a disconnection of the connector, incorrect
installation or breakage of the stack belt exit home position sensor
(S9). If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN18) on the finisher controller PC board is
disconnected from the stack belt exit home position sensor (S9) and
the harnesses are open circuited. Correct if any.
8 - 98
Measures
Remark
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
