Oki ES9160 Maintenance Manual page 466

*m. Buffer tray guide
Apply an adequate amount of white grease (Molykote EM-30L) to the entire buffer tray guide
(inside of the folded section of the plate).
*n. Finishing tray shaft
1. Take off the metal shield plate. If the hole punch unit is installed, take it off beforehand.
2. Apply oil as follows through the opening which shows up when the metal shield plate has been
removed.
Apply an adequate amount of white grease (Molykote EM-30L) to the gear teeth of the rack and
pinion gears which drive the aligning plate, and the entire finishing tray shaft.
Pinion gear
ES9160 MFP / ES9170 MFP
PREVENTIVE MAINTENANCE (PM)
Buffer tray guide
Fig. 7-30
Rack gear
Fig. 7-31
7 - 38
Finishing tray shaft
© 2012 OKI DATA CORPORATION All rights reserved