Advertisement
8.3.19
Finisher related service call
[CB00] Finisher not connected
[CB01] Finisher communication error
Classification
Finisher related service call
Check item
Setting of the equipment
Finisher
Converter
Parts to be replaced
Converter board
Finisher control PC board
[CB01] Finisher communication error
MJ-1033
Error
Data communication error
[CB10] Entrance motor abnormality
Classification
Finisher related service call
MJ-1101
Check Item
Entrance roller
Entrance motor (M1)
Replacement part
Entrance motor (M1)
Finisher controller PC board
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
Finisher not connected
Finisher communication error
•
Check if the MJ-1101, MJ-1106, MJ-1032 or MJ-1033 is set as
the specified finisher on the equipment (08-4548).
•
Check if the harness connecting the equipment and the finisher
controller PC board is disconnected or open circuited.
•
Check if the conductor pattern on the finisher controller PC
board is open circuited or short circuited.
•
Update the finisher firmware.
•
Check if the connector connecting the converter board and the
LGC board on the equipment is disconnected or open circuited.
•
Check if the conductor pattern on the converter PC board is
open circuited or short circuited.
•
Update the converter firmware.
The communication between the equipment and the Finisher is
interrupted. This error is detected by the equipment.
Entrance motor abnormality: The entrance motor is not rotating
normally.
If there is mechanical problem when the entrance roller is
rotated, fix the mechanism.
Check the connectors and harnesses between the entrance
motor (M1) and the finisher control PC board (CN7).
8 - 140
Error content
Measure
Remark
Timing of detection
Contents
Measure
Measure
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
