Advertisement
(4)
Turn the power OFF after the backup is completed.
[B] Return License
(1)
Start up with the Setting Mode (08).
(2)
Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3)
Key in [3840], and then press the [OK] button.
(4)
Select the license to be returned, and then press the [REMOVE] button.
(5)
Install the one-time dongle, which you used for uploading the selected license, in the equipment,
and then press the [OK] button.
(6)
The Remove screen is displayed, then press the [YES] button. If this screen is not displayed,
check whether the one-time dongle is installed in the equipment properly.
(7)
After 10 to 40 seconds passes, the screen for notifying the success of performance is displayed.
Then press the [OK] button. If this screen is not displayed or the screen for notifying the failure of
performance is displayed, quit this operation by pressing the [NO]/[CLOSE] button. Then, check
whether the one-time dongle, which you used for uploading the selected license, is installed in
the equipment.
(8)
Check that the returned license is not displayed on the screen.
Remarks:
If there are any other licenses to be returned, repeat from step (4).
If there is no more licenses to be returned, press the [CLOSE] button, and then turn the power
OFF.
[C] Replace SRAM board
(1)
Confirm that the power is turned OFF.
(2)
If the FAX unit (GD-1250) is installed, disconnect the connector (CN134).
(3)
Replace the SRAM board.
P. 9-5 "9.1.7 SRAM board"
[D] Initialize SRAM system storage area
(1)
Turn the power ON while pressing [6] and [CLEAR] simultaneously.
(2)
When "SRAM Clear Mode" appears on the LCD, key in [1] to select "1. Clear SRAM" and then
press the [START] button.
(3)
When "SRAM Format Completed" is displayed on the LCD, initializing is completed.
(4)
Turn the power OFF.
[E] Restore SRAM
If there is SRAM backup data, perform the following steps.
(1)
Turn the power ON while pressing [6] and the [CLEAR] button simultaneously.
(2)
When "SRAM Clear Mode" appears on the LCD, key in [0] to select "0. Set Serial Number" and
then press the [START] button.
© 2012 OKI DATA CORPORATION All rights reserved
9 - 21
ES9160 MFP / ES9170 MFP
REPLACEMANT OF HDD/PC BOARDS
9
Advertisement
