Advertisement
6.5.2
Adjustment of image density
The image density level can be set at the following codes.
Toner mode
Toner
Toner
General
save
save
(PS)
(PCL)
7350-0
7351-0
7352-0
to 4
to 4
to 4
<Procedure>
(1)
While pressing [0] and [5] simultaneously, turn the power ON.
(2)
Key in a code and press the [START] button.
(3)
Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4)
Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5)
Press the [OK] or [INTERRUPT] button to store the value in memory. The equipment goes back
to the ready state.
(6)
For resetting the value, repeat step (2) to (5).
(7)
Turn the power OFF and then back ON to perform printing job.
(8)
If the desired image density has not been attained, repeat step (2) to (7).
© 2012 OKI DATA CORPORATION All rights reserved
Hardco
Item to be
Toner
py
adjusted
save
security
(XPS)
printing
7353-0
7354-0
Adjustment
to 4
to 4
of image
density
6 - 31
< Adjustment Mode (05) >
Remarks
When the value is decreased, text becomes
lighter.
Acceptable values: 0 to 10
Notes:
1. Set not to reverse the large and
small number of the setting value
corresponding to the sub code.
Ex.) When the image density
level for 7350-0, 7300-1, 7350-2,
7350-3, and 7350-4 is assumed
to be "A","B", "C", "D", and "E"
respectively, they should have the
following correlation:
2.
A
B
C
D
E
Remember that the image
specifications and life span of the
replacing parts may not meet the
standard when the setting value
is changed from the default value.
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6
Advertisement
