Notes:
When installing the thermistors, check the
length of the harness first and distinguish the
installation positions of the side thermistor
and edge thermistor by the length of each
harness.
4.9.7
Fuser center / Fuser front thermostat (THMO1/THMO2)
(1)
Take off the fuser roller unit
(
P. 4-76 "4.9.2 Fuser roller unit / Pressure
roller unit").
(2)
Place the fuser roller unit [1] upside down.
(3)
Remove 2 screws, and then take off the
harness cover [2].
Notes:
When installing the harness cover [2], make
sure that the harness is not caught.
(4)
Remove 2 screws, and then take off the
fuser front thermostat [1].
© 2012 OKI DATA CORPORATION All rights reserved
Edge thermistor
Fig. 4-227
[1]
Fig. 4-228
[1]
Fig. 4-229
4 - 81
Side thermistor
Center thermistor
[2]
ES9160 MFP / ES9170 MFP
DISASSEMBLY AND REPLACEMENT
4