Advertisement
(6)
Take off the converter PC board from the logic PC board (LGC board)
(7)
Connect the 10-pin side of the harness jig for board connection (HRNS-CNV-DL-JIG) to the
connector (CN2) of the converter PC board [1].
(8)
Connect the 15-pin side of the harness jig for board connection to the connector (CN4) of the IF
board.
CN4
Notes:
•
Be sure to release the connection cable from the connector (CN4) of the IF board when the
hole punch unit (MJ-6103) has been installed.
•
Be careful not to short-circuit any part of the converter PC board.
© 2012 OKI DATA CORPORATION All rights reserved
Fig.11-65
[1]
CN2
Fig.11-66
Fig.11-67
11 - 65
ES9160 MFP / ES9170 MFP
FIRMWARE UPDATING
11
Advertisement
