Advertisement
[K] Reinstall license
If the license was returned in "[B]Return License", reinstall it with the following procedure.
(1)
Turn the power ON while pressing [0] and [8] simultaneously.
(2)
Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3)
Key in [3840], and then press the [START] button.
(4)
Press the [INSTALL] button.
(5)
Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
(6)
Select the license to be installed, and then press the [INSTALL] button.
(7)
The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(8)
After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
(9)
Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be installed, repeat from step (4). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
[L] Enable HDD encryption
If the HDD encryption function is used, follow the procedure below.
(1)
Start up with the Setting mode (08).
(2)
Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3)
Enable the HDD encryption function. (Set "3" for 08-8911. Or set "1" for 08-8911 and "1" or "2" for
08-9379.)
(4)
Turn the power OFF.
[M] Adjust image quality
(1)
Start up with the Adjustment mode (05).
(2)
Perform "Data transfer of characteristic value of scanner" (05-3203).
(3)
Perform "Automatic gamma adjustment" <PPC> (05-7165).
P. 6-22 "6.4.1 Automatic gamma adjustment"
(4)
Turn the power OFF.
[N] Initialize settings when FAX Unit (GD-1250) is installed
ES9160 MFP / ES9170 MFP
REPLACEMANT OF HDD/PC BOARDS
© 2012 OKI DATA CORPORATION All rights reserved
9 - 24
Advertisement
